![]() ![]() Navigating the menus on the color touch screen is easy because there are only three sub menus: Print, System and Tools. ![]() ![]() The port is located on the side with the power switch, situated where you’re unlikely to drip resin. Unlike its FDM printer cousins, the Anycubic Photon M3 reads files from a USB stick rather than a microSD card. ![]() It comes with a screen protector for the LED glass, which is a nice touch. The top of the plate sloped without any crevices to catch stray resin. The build plate is laser etched for just the right amount of grip, and I had no problems removing prints with the metal scrapper provided. Otherwise the printer and fan are remarkably quiet. It has a single yet sturdy Z axis rail and makes a pleasant hum when traveling up and down the rail. The machine feels solid and is made of metal where it counts – on the Z axis and around the LED screen. It has a square base made of dark plastic and a brightly-colored transparent plastic cover. The Anycubic Photon M3 has a design typical of smaller desktop resin printers. If you haven’t installed the provided screen protector, now is a good time to do it. If, for any reason, you don’t see the full image, contact service for help. Press Tools → Detection → and select an image and the amount of time it should flash. Raise the build plate up (Move Z) until you can see the LED lights inside the machine. Now tighten the screws.Ĭlick Tools → Z=0 on the touch screen. Press the build plate firm and evenly to the glass. The Z axis will lower and stop automatically. Place the build plate on the Z axis and tighten the top knob.Click the Home symbol on the touch screen. Loosen the four adjustment screws on the sides of the build plate. To level the machine, remove the vat and then place the piece of paper provided by Anycubic on the LCD screen. Leveling the build plate is fairly straightforward and only takes a piece of paper and an Allen wrench. Like all 3D printers, the Anycubic Photon M3 requires calibration before its first print. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |